D68 Aluminium - 47PZ - 215mm Centres

Replacement 47PZ Aluminium door handles

A few tips!

These 47PZ Aluminium door handles are used on exterior upvc doors where a specific size multi-point lock exists. Be sure to measure the sizes correctly to ensure you have the correct set of replacement handles.

For further help please visit our video how to replace upvc door handles.

Your current handle must have the following sizes to use the D68:

Size A: 47PZ - this is the 47mm size between the centre of the cylinder lock and the centre of the lever handle (spindle).

Size B: Top screw hole centre to lever centre (spindle) of 95mm.

Size C: Size between the screw centres of 215mm.

Door Handle Screws For 47PZ Aluminium Double Glazed Door Handle (D68)

It is important to check the thickness of your door to ensure that the screw pack sent with the 47PZ Aluminium door handle is correct otherwise the door handle screw may be too short or too long (in this case you can hacksaw them down to size).

The 47PZ Aluminium door handle is supplied with a spindle length of 120mm and 160mm and also 45mm, 70mm and 80mm long screws. These will fit a door thickness between 27-36mm and 60-70mm.

If your door thickness falls outside of this size range then you need to purchase or cut down (if appropriate) further screws and a spindle. Here are some examples:

These links will direct you to the door handle screws and door handle spindles.

Notes:

** 100 000 test cycles relates to a handle mounted correctly on a door with one open/close motion = 1 cycle.

Special cleaning is not necessary for any of the finishes shown as dirt can be removed with a damp cloth. The use of caustic cleaners or chemicals should be avoided.