D63 Mila Prolinea - 92PZ - 211mm Centres

Replacement Prolinea 92pz upvc door handles

A few tips!

These Hoppe Prolinea 92pz upvc door handles are used on exterior upvc doors where a specific size multi-point lock exists. Be sure to measure the sizes correctly to ensure you have the correct set of replacement handles.

For further help please visit our video how to replace upvc door handles.

Your current handle must have the following sizes to use the D63:

Size A: 92PZ - this is the 92mm size between the centre of the cylinder lock and the centre of the lever handle (spindle).

Size B: Top screw hole centre to lever centre (spindle) of 75mm.

Size C: Size between the screw centres of 211mm.

Door Handle Screws For Prolinea 92PZ uPVC Door Handle (D63)

It is important to check the thickness of your door to ensure that the screw pack sent with the Prolinea 92PZ uPVC door handle is correct otherwise the door handle screw may be too short or too long (in this case you can hacksaw them down to size).

The Prolinea 92PZ door handle is supplied with a spindle length of 130mm and also 73mm and 83mm long screws. These will fit a door thickness between 60 and 68mm.

If your door thickness falls outside of this size range then you need to purchase or cut down (if appropriate) further screws and a spindle. Here are some examples:

These links will direct you to the door handle screws and door handle spindles.

Notes:

Special cleaning is not necessary for any of the finishes shown as dirt can be removed with a damp cloth. The use of caustic cleaners or chemicals should be avoided.

These handles must not be used in sea or coastal designated areas to protect against surface degradation. Please see our terms and conditions.